Loading...
Note: File does not exist in v3.1.
1// SPDX-License-Identifier: GPL-2.0-only
2/* stnic.c : A SH7750 specific part of driver for NS DP83902A ST-NIC.
3 *
4 * Copyright (C) 1999 kaz Kojima
5 */
6
7#include <linux/module.h>
8#include <linux/kernel.h>
9#include <linux/errno.h>
10#include <linux/interrupt.h>
11#include <linux/ioport.h>
12#include <linux/netdevice.h>
13#include <linux/etherdevice.h>
14#include <linux/init.h>
15#include <linux/delay.h>
16
17#include <asm/io.h>
18#include <mach-se/mach/se.h>
19#include <asm/machvec.h>
20#ifdef CONFIG_SH_STANDARD_BIOS
21#include <asm/sh_bios.h>
22#endif
23
24#include "8390.h"
25
26#define DRV_NAME "stnic"
27
28#define byte unsigned char
29#define half unsigned short
30#define word unsigned int
31#define vbyte volatile unsigned char
32#define vhalf volatile unsigned short
33#define vword volatile unsigned int
34
35#define STNIC_RUN 0x01 /* 1 == Run, 0 == reset. */
36
37#define START_PG 0 /* First page of TX buffer */
38#define STOP_PG 128 /* Last page +1 of RX ring */
39
40/* Alias */
41#define STNIC_CR E8390_CMD
42#define PG0_RSAR0 EN0_RSARLO
43#define PG0_RSAR1 EN0_RSARHI
44#define PG0_RBCR0 EN0_RCNTLO
45#define PG0_RBCR1 EN0_RCNTHI
46
47#define CR_RRD E8390_RREAD
48#define CR_RWR E8390_RWRITE
49#define CR_PG0 E8390_PAGE0
50#define CR_STA E8390_START
51#define CR_RDMA E8390_NODMA
52
53/* FIXME! YOU MUST SET YOUR OWN ETHER ADDRESS. */
54static byte stnic_eadr[6] =
55{0x00, 0xc0, 0x6e, 0x00, 0x00, 0x07};
56
57static struct net_device *stnic_dev;
58
59static void stnic_reset (struct net_device *dev);
60static void stnic_get_hdr (struct net_device *dev, struct e8390_pkt_hdr *hdr,
61 int ring_page);
62static void stnic_block_input (struct net_device *dev, int count,
63 struct sk_buff *skb , int ring_offset);
64static void stnic_block_output (struct net_device *dev, int count,
65 const unsigned char *buf, int start_page);
66
67static void stnic_init (struct net_device *dev);
68
69static u32 stnic_msg_enable;
70
71module_param_named(msg_enable, stnic_msg_enable, uint, 0444);
72MODULE_PARM_DESC(msg_enable, "Debug message level (see linux/netdevice.h for bitmap)");
73
74/* SH7750 specific read/write io. */
75static inline void
76STNIC_DELAY (void)
77{
78 vword trash;
79 trash = *(vword *) 0xa0000000;
80 trash = *(vword *) 0xa0000000;
81 trash = *(vword *) 0xa0000000;
82}
83
84static inline byte
85STNIC_READ (int reg)
86{
87 byte val;
88
89 val = (*(vhalf *) (PA_83902 + ((reg) << 1)) >> 8) & 0xff;
90 STNIC_DELAY ();
91 return val;
92}
93
94static inline void
95STNIC_WRITE (int reg, byte val)
96{
97 *(vhalf *) (PA_83902 + ((reg) << 1)) = ((half) (val) << 8);
98 STNIC_DELAY ();
99}
100
101static int __init stnic_probe(void)
102{
103 struct net_device *dev;
104 struct ei_device *ei_local;
105 int err;
106
107 /* If we are not running on a SolutionEngine, give up now */
108 if (! MACH_SE)
109 return -ENODEV;
110
111 /* New style probing API */
112 dev = alloc_ei_netdev();
113 if (!dev)
114 return -ENOMEM;
115
116#ifdef CONFIG_SH_STANDARD_BIOS
117 sh_bios_get_node_addr (stnic_eadr);
118#endif
119 eth_hw_addr_set(dev, stnic_eadr);
120
121 /* Set the base address to point to the NIC, not the "real" base! */
122 dev->base_addr = 0x1000;
123 dev->irq = IRQ_STNIC;
124 dev->netdev_ops = &ei_netdev_ops;
125
126 /* Snarf the interrupt now. There's no point in waiting since we cannot
127 share and the board will usually be enabled. */
128 err = request_irq (dev->irq, ei_interrupt, 0, DRV_NAME, dev);
129 if (err) {
130 netdev_emerg(dev, " unable to get IRQ %d.\n", dev->irq);
131 free_netdev(dev);
132 return err;
133 }
134
135 ei_status.name = dev->name;
136 ei_status.word16 = 1;
137#ifdef __LITTLE_ENDIAN__
138 ei_status.bigendian = 0;
139#else
140 ei_status.bigendian = 1;
141#endif
142 ei_status.tx_start_page = START_PG;
143 ei_status.rx_start_page = START_PG + TX_PAGES;
144 ei_status.stop_page = STOP_PG;
145
146 ei_status.reset_8390 = &stnic_reset;
147 ei_status.get_8390_hdr = &stnic_get_hdr;
148 ei_status.block_input = &stnic_block_input;
149 ei_status.block_output = &stnic_block_output;
150
151 stnic_init (dev);
152 ei_local = netdev_priv(dev);
153 ei_local->msg_enable = stnic_msg_enable;
154
155 err = register_netdev(dev);
156 if (err) {
157 free_irq(dev->irq, dev);
158 free_netdev(dev);
159 return err;
160 }
161 stnic_dev = dev;
162
163 netdev_info(dev, "NS ST-NIC 83902A\n");
164
165 return 0;
166}
167
168static void
169stnic_reset (struct net_device *dev)
170{
171 struct ei_device *ei_local = netdev_priv(dev);
172
173 *(vhalf *) PA_83902_RST = 0;
174 udelay (5);
175 netif_warn(ei_local, hw, dev, "8390 reset done (%ld).\n", jiffies);
176 *(vhalf *) PA_83902_RST = ~0;
177 udelay (5);
178}
179
180static void
181stnic_get_hdr (struct net_device *dev, struct e8390_pkt_hdr *hdr,
182 int ring_page)
183{
184 struct ei_device *ei_local = netdev_priv(dev);
185
186 half buf[2];
187
188 STNIC_WRITE (PG0_RSAR0, 0);
189 STNIC_WRITE (PG0_RSAR1, ring_page);
190 STNIC_WRITE (PG0_RBCR0, 4);
191 STNIC_WRITE (PG0_RBCR1, 0);
192 STNIC_WRITE (STNIC_CR, CR_RRD | CR_PG0 | CR_STA);
193
194 buf[0] = *(vhalf *) PA_83902_IF;
195 STNIC_DELAY ();
196 buf[1] = *(vhalf *) PA_83902_IF;
197 STNIC_DELAY ();
198 hdr->next = buf[0] >> 8;
199 hdr->status = buf[0] & 0xff;
200#ifdef __LITTLE_ENDIAN__
201 hdr->count = buf[1];
202#else
203 hdr->count = ((buf[1] >> 8) & 0xff) | (buf[1] << 8);
204#endif
205
206 netif_dbg(ei_local, probe, dev, "ring %x status %02x next %02x count %04x.\n",
207 ring_page, hdr->status, hdr->next, hdr->count);
208
209 STNIC_WRITE (STNIC_CR, CR_RDMA | CR_PG0 | CR_STA);
210}
211
212/* Block input and output, similar to the Crynwr packet driver. If you are
213 porting to a new ethercard look at the packet driver source for hints.
214 The HP LAN doesn't use shared memory -- we put the packet
215 out through the "remote DMA" dataport. */
216
217static void
218stnic_block_input (struct net_device *dev, int length, struct sk_buff *skb,
219 int offset)
220{
221 char *buf = skb->data;
222 half val;
223
224 STNIC_WRITE (PG0_RSAR0, offset & 0xff);
225 STNIC_WRITE (PG0_RSAR1, offset >> 8);
226 STNIC_WRITE (PG0_RBCR0, length & 0xff);
227 STNIC_WRITE (PG0_RBCR1, length >> 8);
228 STNIC_WRITE (STNIC_CR, CR_RRD | CR_PG0 | CR_STA);
229
230 if (length & 1)
231 length++;
232
233 while (length > 0)
234 {
235 val = *(vhalf *) PA_83902_IF;
236#ifdef __LITTLE_ENDIAN__
237 *buf++ = val & 0xff;
238 *buf++ = val >> 8;
239#else
240 *buf++ = val >> 8;
241 *buf++ = val & 0xff;
242#endif
243 STNIC_DELAY ();
244 length -= sizeof (half);
245 }
246
247 STNIC_WRITE (STNIC_CR, CR_RDMA | CR_PG0 | CR_STA);
248}
249
250static void
251stnic_block_output (struct net_device *dev, int length,
252 const unsigned char *buf, int output_page)
253{
254 STNIC_WRITE (PG0_RBCR0, 1); /* Write non-zero value */
255 STNIC_WRITE (STNIC_CR, CR_RRD | CR_PG0 | CR_STA);
256 STNIC_DELAY ();
257
258 STNIC_WRITE (PG0_RBCR0, length & 0xff);
259 STNIC_WRITE (PG0_RBCR1, length >> 8);
260 STNIC_WRITE (PG0_RSAR0, 0);
261 STNIC_WRITE (PG0_RSAR1, output_page);
262 STNIC_WRITE (STNIC_CR, CR_RWR | CR_PG0 | CR_STA);
263
264 if (length & 1)
265 length++;
266
267 while (length > 0)
268 {
269#ifdef __LITTLE_ENDIAN__
270 *(vhalf *) PA_83902_IF = ((half) buf[1] << 8) | buf[0];
271#else
272 *(vhalf *) PA_83902_IF = ((half) buf[0] << 8) | buf[1];
273#endif
274 STNIC_DELAY ();
275 buf += sizeof (half);
276 length -= sizeof (half);
277 }
278
279 STNIC_WRITE (STNIC_CR, CR_RDMA | CR_PG0 | CR_STA);
280}
281
282/* This function resets the STNIC if something screws up. */
283static void
284stnic_init (struct net_device *dev)
285{
286 stnic_reset (dev);
287 NS8390_init (dev, 0);
288}
289
290static void __exit stnic_cleanup(void)
291{
292 unregister_netdev(stnic_dev);
293 free_irq(stnic_dev->irq, stnic_dev);
294 free_netdev(stnic_dev);
295}
296
297module_init(stnic_probe);
298module_exit(stnic_cleanup);
299MODULE_DESCRIPTION("National Semiconductor DP83902AV ethernet driver");
300MODULE_LICENSE("GPL");