1/*
 2 * wm8962.h  --  WM8962 Soc Audio driver platform data
 3 *
 4 * This program is free software; you can redistribute it and/or modify
 5 * it under the terms of the GNU General Public License version 2 as
 6 * published by the Free Software Foundation.
 7 */
 8
 9#ifndef _WM8962_PDATA_H
10#define _WM8962_PDATA_H
11
12#define WM8962_MAX_GPIO 6
13
14/* Use to set GPIO default values to zero */
15#define WM8962_GPIO_SET 0x10000
16
17#define WM8962_GPIO_FN_CLKOUT           0
18#define WM8962_GPIO_FN_LOGIC            1
19#define WM8962_GPIO_FN_SDOUT            2
20#define WM8962_GPIO_FN_IRQ              3
21#define WM8962_GPIO_FN_THERMAL          4
22#define WM8962_GPIO_FN_PLL2_LOCK        6
23#define WM8962_GPIO_FN_PLL3_LOCK        7
24#define WM8962_GPIO_FN_FLL_LOCK         9
25#define WM8962_GPIO_FN_DRC_ACT         10
26#define WM8962_GPIO_FN_WSEQ_DONE       11
27#define WM8962_GPIO_FN_ALC_NG_ACT      12
28#define WM8962_GPIO_FN_ALC_PEAK_LIMIT  13
29#define WM8962_GPIO_FN_ALC_SATURATION  14
30#define WM8962_GPIO_FN_ALC_LEVEL_THR   15
31#define WM8962_GPIO_FN_ALC_LEVEL_LOCK  16
32#define WM8962_GPIO_FN_FIFO_ERR        17
33#define WM8962_GPIO_FN_OPCLK           18
34#define WM8962_GPIO_FN_DMICCLK         19
35#define WM8962_GPIO_FN_DMICDAT         20
36#define WM8962_GPIO_FN_MICD            21
37#define WM8962_GPIO_FN_MICSCD          22
38
39struct wm8962_pdata {
 
40	int gpio_base;
41	u32 gpio_init[WM8962_MAX_GPIO];
42
43	/* Setup for microphone detection, raw value to be written to
44	 * R48(0x30) - only microphone related bits will be updated.
45	 * Detection may be enabled here for use with signals brought
46	 * out on the GPIOs. */
47	u32 mic_cfg;
48
49	bool irq_active_low;
50
51	bool spk_mono;   /* Speaker outputs tied together as mono */
 
 
 
 
 
 
52};
53
54#endif

 1/*
 2 * wm8962.h  --  WM8962 Soc Audio driver platform data
 3 *
 4 * This program is free software; you can redistribute it and/or modify
 5 * it under the terms of the GNU General Public License version 2 as
 6 * published by the Free Software Foundation.
 7 */
 8
 9#ifndef _WM8962_PDATA_H
10#define _WM8962_PDATA_H
11
12#define WM8962_MAX_GPIO 6
13
14/* Use to set GPIO default values to zero */
15#define WM8962_GPIO_SET 0x10000
16
17#define WM8962_GPIO_FN_CLKOUT           0
18#define WM8962_GPIO_FN_LOGIC            1
19#define WM8962_GPIO_FN_SDOUT            2
20#define WM8962_GPIO_FN_IRQ              3
21#define WM8962_GPIO_FN_THERMAL          4
22#define WM8962_GPIO_FN_PLL2_LOCK        6
23#define WM8962_GPIO_FN_PLL3_LOCK        7
24#define WM8962_GPIO_FN_FLL_LOCK         9
25#define WM8962_GPIO_FN_DRC_ACT         10
26#define WM8962_GPIO_FN_WSEQ_DONE       11
27#define WM8962_GPIO_FN_ALC_NG_ACT      12
28#define WM8962_GPIO_FN_ALC_PEAK_LIMIT  13
29#define WM8962_GPIO_FN_ALC_SATURATION  14
30#define WM8962_GPIO_FN_ALC_LEVEL_THR   15
31#define WM8962_GPIO_FN_ALC_LEVEL_LOCK  16
32#define WM8962_GPIO_FN_FIFO_ERR        17
33#define WM8962_GPIO_FN_OPCLK           18
34#define WM8962_GPIO_FN_DMICCLK         19
35#define WM8962_GPIO_FN_DMICDAT         20
36#define WM8962_GPIO_FN_MICD            21
37#define WM8962_GPIO_FN_MICSCD          22
38
39struct wm8962_pdata {
40	struct clk *mclk;
41	int gpio_base;
42	u32 gpio_init[WM8962_MAX_GPIO];
43
44	/* Setup for microphone detection, raw value to be written to
45	 * R48(0x30) - only microphone related bits will be updated.
46	 * Detection may be enabled here for use with signals brought
47	 * out on the GPIOs. */
48	u32 mic_cfg;
49
50	bool irq_active_low;
51
52	bool spk_mono;   /* Speaker outputs tied together as mono */
53
54	/**
55	 * This flag should be set if one or both IN4 inputs is wired
56	 * in a DC measurement configuration.
57	 */
58	bool in4_dc_measure;
59};
60
61#endif